Go Back   The Supercar Registry > Search Forums


Showing results 1 to 25 of 73
Search took 0.00 seconds.
Search: Posts Made By: tjs44
Forum: Pontiac 02-27-2024, 04:48 PM
Replies: 41
Views: 3,205
Posted By tjs44
That was Jess Tyree driving my car back in...

That was Jess Tyree driving my car back in 1964.Damn he had a large head!Tom
Forum: Pontiac 02-16-2024, 09:35 PM
Replies: 41
Views: 3,205
Posted By tjs44
1963 326HO 3 speed.Ended racing in AMP and SS...

1963 326HO 3 speed.Ended racing in AMP and SS until 1972.
Forum: Supercars/Musclecars-For Sale 02-07-2024, 02:22 PM
Replies: 1
Views: 566
Posted By tjs44
FWI,its a 63!Tom

FWI,its a 63!Tom
Forum: Pit Area - Racing 11-27-2023, 10:23 PM
Replies: 14
Views: 8,370
Posted By tjs44
I have done 3 of them.If doing a new now I would...

I have done 3 of them.If doing a new now I would use a ford 9 inch with coil overs and ladder bars.They are a unibody car so if using a pan hard bar if mounted to the unibody rail it will have to be...
Forum: Ebay & other seen ads section 10-12-2023, 05:29 PM
Replies: 15
Views: 3,383
Posted By tjs44
I restored a 69 Judge,that will cost a lot to...

I restored a 69 Judge,that will cost a lot to just make a nice driver IMO.Tom
Forum: Supercar/Musclecar Discussion 08-25-2023, 11:29 PM
Replies: 37
Views: 7,389
Posted By tjs44
Pay attention to valve stems also.I was getting...

Pay attention to valve stems also.I was getting on the freeway with my 63 421 Lemans and blew out a RT front stem,was lucky I had room to get over and not hit anything.FWIW,Tom
Forum: COPO - United States 08-15-2023, 02:51 PM
Replies: 73
Views: 145,000
Posted By tjs44
I think #64 was bought new by Bill Turner in Ft...

I think #64 was bought new by Bill Turner in Ft Myers FLA,when I saw it had a repaint in Silver,engine had been pulled and stored and the car raced with a dif engine.Dont remember when he sold...
Forum: Pontiac 06-22-2023, 02:37 AM
Replies: 7
Views: 2,362
Posted By tjs44
FYI,the forged 58-62 rods were called the rubber...

FYI,the forged 58-62 rods were called the rubber rods,low heat treating.The next were better but not as good as the 421SDs.Myself I would use aftermarket forged over any of the factory early forged...
Forum: Pontiac 06-22-2023, 02:24 AM
Replies: 7
Views: 2,362
Posted By tjs44
The good early forged rods are the 421SDs.The...

The good early forged rods are the 421SDs.The bolt length is the diff from the pass car rods.Will look it up tomorrow and get back to you.Tom
Forum: Pontiac 04-25-2023, 03:39 AM
Replies: 3
Views: 1,125
Posted By tjs44
I first met Fritz in around 1964,I used to go...

I first met Fritz in around 1964,I used to go down the M/Ts on Coda street in LB and buy their cast of stuff and sell it to fuel my racing back then.MT would come up with the ideas and it was Fritz...
Forum: Ebay & other seen ads section 04-23-2023, 01:32 AM
Replies: 10
Views: 2,551
Posted By tjs44
He actually left her 3 non running cars!62 Cat...

He actually left her 3 non running cars!62 Cat sedan,im finishing the 62 421 SD engine for it now,a 61 Ventura 4 speed and a V8 Pinto with a Rover alu V8.Also a 64 Corvette that we cant see yet as it...
Forum: Other Muscle 02-25-2023, 10:56 PM
Replies: 96
Views: 129,400
Posted By tjs44
The 455SD was designed as a race engine but GM...

The 455SD was designed as a race engine but GM got their hand slapped when caught messing with emission.The block is a 4 bolt main with all joined lifter bores like the RA Vs and also provisions for...
Forum: Parts/Memorabilia - Wanted 02-24-2023, 01:30 AM
Replies: 4
Views: 1,418
Posted By tjs44
Thats what car guys do!It was about 4 miles from...

Thats what car guys do!It was about 4 miles from SMI and had the take a carb to Sean to checkout so was NBD.Will get back down and pick it up ASAP.Hope to be able to get them and ship them out 3-6.Tom
Forum: Parts/Memorabilia - Wanted 02-21-2023, 02:42 PM
Replies: 4
Views: 1,418
Posted By tjs44
my text is 5622430570.I might be down in HB...

my text is 5622430570.I might be down in HB Friday.Tom
Forum: Ebay & other seen ads section 02-09-2023, 03:48 PM
Replies: 6
Views: 1,702
Posted By tjs44
I asked if the car had its born with original...

I asked if the car had its born with original block carb and dizzy,if not are they correct for the date of the car.The correct carbs are stupid expensive now.Tom
Forum: Ebay & other seen ads section 12-23-2022, 08:57 PM
Replies: 10
Views: 2,656
Posted By tjs44
DAMN!If I had that car and the owner had a...

DAMN!If I had that car and the owner had a feather up his butt we would both be tickled!
Forum: Parts/Memorabilia - For Sale 11-13-2022, 02:45 AM
Replies: 4
Views: 1,504
Posted By tjs44
Pontiac 65 and up 2-4 Bathtub tunnel ram intake for sale

Reproduction of the 421 Super Duty Factory tunnel ram intake.$2500 plus shipping
Forum: Technical & Restoration 10-24-2022, 02:22 AM
Replies: 11
Views: 3,517
Posted By tjs44
White vinegar and a length of chain.Seal it off...

White vinegar and a length of chain.Seal it off and just rotate the crap out of it,draining and replacing it until comes out pretty clear.Wash it out good and then a good wet dry vac.I would have...
Forum: Lounge 10-02-2022, 02:24 AM
Replies: 2
Views: 1,317
Posted By tjs44
Made Donuts real light today.Tom

Made Donuts real light today.Tom
Forum: Lounge 09-24-2022, 02:29 AM
Replies: 2
Views: 1,317
Posted By tjs44
Cruisen for a cure car show OCFair Ground

Anyone on the board going to beat the show tomorrow?Will be inside one of the buildings.Gold 63 421 Lemans.Tom
Forum: Pontiac 08-31-2022, 09:46 PM
Replies: 7
Views: 2,342
Posted By tjs44
MBZ bought that car right after the race.It has...

MBZ bought that car right after the race.It has NEVER surfaced.Tom
Forum: Lounge 07-29-2022, 02:57 AM
Replies: 1
Views: 1,167
Posted By tjs44
OPG car show July 30th

Any one on the board attending?Will have my 63 421 Lemans there.Tom
Forum: Ebay & other seen ads section 06-25-2022, 11:08 PM
Replies: 4
Views: 1,832
Posted By tjs44
trunk pan.Tom

trunk pan.Tom
Forum: Technical & Restoration 06-15-2022, 03:27 AM
Replies: 16
Views: 6,645
Posted By tjs44
I use 10-30 Mobil 1 in all roller and hyd roller...

I use 10-30 Mobil 1 in all roller and hyd roller cam cars as it comes out of the bottle.No additives.Tom
Forum: Technical & Restoration 06-14-2022, 01:55 PM
Replies: 16
Views: 6,645
Posted By tjs44
I use 10-30 dyno oil with a 1/2 bottle of GM EOS...

I use 10-30 dyno oil with a 1/2 bottle of GM EOS and 1/2 bottle of STP after break in.Tom
Showing results 1 to 25 of 73

 
Forum Jump

All times are GMT. The time now is 01:41 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.

O Garage vBulletin Plugins by Drive Thru Online, Inc.