The Supercar Registry - Build Sheet Question

The Supercar Registry (https://www.yenko.net/forum/index.php)

- Preservation forum (https://www.yenko.net/forum/forumdisplay.php?f=138)

- - Build Sheet Question (https://www.yenko.net/forum/showthread.php?t=139024)

Quote:

Originally Posted by WILMASBOYL78 (Post 1461338)

The buildsheet code 'M20'...does not indicate the specific transmission installed, eg; M20, M21 or M22...this code simply told the Fisher Body folks they needed to cut a hole in the floor for a manual trans. shifter. This is a very common point of confusion when folks look at the Fisher buildsheets. Basically the sheet indicated any work needed to the body to facilitate installing various options like; trim and moldings, floor shifters, consoles, decor packages, etc.

-wilma

Was that a Willow Run thing? Flint 68 and 69 fullsize used the same type of card and I've seen M21 and M22 transmission rpo codes listed on them.

Those are Fisher Body broadcast codes.

Piecing a sheet back together is time consuming... I did my 68 GTO sheet which was in alot of pieces, I used a piece of ACID free archival illustration board and archival glue used a pair of tweezers and put the pieces in place... then covered with a sleeve which protects it from UV light.