Endura bumper question
 

A friend and I are starting to restore one for his 69 Z/28. Did the factory paint the backside of the endura bumpers? Or what is the proper procedure? Thank you!

I am curious to see the answer on this one myself.

I acquired this original VE3 bumper for replacement use on my yellow Z/28 and believe this one had original paint before being restored last year. You can see overspray at the back of both ends, and some overspray up from underneath where the inner brackets are located. Also looked to have had some overspray along the top inner edges but only slight. Other than that, there was very little paint overspray on the backside of this one. Seen in the last picture, the brackets did have overspray on them.

I don't know if these were pre painted on a buck before they were mounted onto the cars but would have thought they were painted off the car?

Hope that helps you out?

https://i.ibb.co/J2z0Lvp/IMG-1771.jpg

https://i.ibb.co/KGVhgQW/IMG-1772.jpg

https://i.ibb.co/6sYCsxr/116130612-2...01322189-n.jpg

https://i.ibb.co/Qn0TsN6/115951661-2...21098843-n.jpg

https://i.ibb.co/YXbKkX8/IMG-1609.jpg

I would think they came in primer from supplier. And painted off the car as the front valance. No overspray on the brackets.