Turbo 400 Case Connector Install
1 Attachment(s)
Is there a trick to installing these Turbo 400 case connectors? My original was replaced a month ago because it was severely leaking and loose. Bought another with an o-ring, dropped the pan, removed the old one which had a broken tab that I located, installed the new one and the pan, refilled the ATF, and all was good for about a month. The connector was tight, but now is somewhat loose and is leaking again.
Thinking about buying another connector and using a larger o-ring, or salvaging this one. Did I miss a step installing this one? BTW, the photo is upside down. Thanks. |
Did the o-ring get cut during install? That, or the o-ring material isn’t compatible with ATF, or the terminal potting has pulled away from the plastic and it’s leaking past the interface.
|
Never though of ATF compatibility with the o-ring. I'll be dropping the pan soon, again.
|
All times are GMT. The time now is 08:07 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.