|
Monojet Rebuild...
1 Attachment(s)
Well this is a first for me...hope Eric can handle the pressure of a 1 barrel fuel mixer https://www.yenko.net/ubbthreads/imag...ins/tongue.gif This old carb has plenty of dirt and grime to clean up....but I know he can do the job...here are some before pics...it will go to him tomorrow.
https://www.yenko.net/attachments/388248-tn_IMG_0451.jpg wilma |
Re: Monojet Rebuild...
1 Attachment(s)
|
Re: Monojet Rebuild...
1 Attachment(s)
|
Re: Monojet Rebuild...
1 Attachment(s)
|
Re: Monojet Rebuild...
Keep us posted on that bad boy Tom!! https://www.yenko.net/ubbthreads/imag...iggthumpup.gif
|
Re: Monojet Rebuild...
[ QUOTE ]
https://www.yenko.net/attachments/388248-tn_IMG_0451.jpg [/ QUOTE ] Hey, I know that hammer! You been in my toolbox? |
Re: Monojet Rebuild...
Dennis, just a little home made repair with some duct tape...look closely at the temp. sending unit. I went to diconnect the wire and the front of the sender crumbled in my hand https://www.yenko.net/ubbthreads/imag...ns/shocked.gif Lots of the little plastic stuff bit the dust...carb is on it's way to Dr. Eric for "cosmetic and functional improvement". I told him not to make it a double pumper https://www.yenko.net/ubbthreads/imag...mlins/grin.gif
wilma |
Re: Monojet Rebuild...
Tom is having Eric plumb it for nitrous...
He can't fool us! https://www.yenko.net/ubbthreads/images/graemlins/no.gif https://www.yenko.net/ubbthreads/imag...ns/scholar.gif https://www.yenko.net/ubbthreads/imag...mlins/grin.gif |
Re: Monojet Rebuild...
1 Attachment(s)
OK Bruce, you caught me...I might as well fess up. Here is a picture of what it will look like in a few days https://www.yenko.net/ubbthreads/imag...ins/3gears.gif
https://www.yenko.net/attachments/388520-tn_6cyl.jpg |
Re: Monojet Rebuild...
|
| All times are GMT. The time now is 08:08 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.