WTB Holley Manifold Studs
 

Need up to (4). Factory or after market with same thread lead and length. 5/16-18 & 24. Looks like cad finish. PM or e-mail. [email protected]

Intake studs
 

I have NOS ones #333959 that replaced #3967475 if you are interested....

Thanks for the offer. I previously looked at cutting down the lead on a 333959, but doing so leaves the thread short. AMK sells a stud that can possibly be modified to the correct length. However, before I go that route, I'll see if anyone has any like those in the pics.

look up member Enoch...i saw some he had listed not too long ago

Thanks for the reply. I've been watching Rich's posts for a while. He did have a set that were for I believe an early Vette. They were shorter than the ones I need.

Intake studs
 

Here is a few updated pictures with digital calipers....

I'm not sure what your application is but I think these may be correct for you. These are off of a 1971-1972 3959594 LT-1 intake. I planned on reinstalling them on the intake but I would be open to selling them.


Jason

pm sent