![]() |
4 Carb Blower Manifold
7 Attachment(s)
I found this manifold at a swap meet and was told it was for a "Blown Flathead". I assume the round hole in the bottom is for attachment to the supercharger? What I don't understand is the round duct at the front? If the carbs are drawing air in what purpose does that opening in the front do? I have seen Potvin front mounted superchargers but the carb manifolds did not have the front opening..The manifold could work on any type engine including a flathead if you had the correct intake..... Any ideas?
|
All times are GMT. The time now is 05:52 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.