C3 take off calipers - front & rear - 1969 Corvette
 

Hi Gang,

I have one set of third design front and rear calipers for C3 1972 - 1982 Corvette Vette available here - these are very recent take offs of a 1969 that got a full Wildwood upgrade - even though they're off a car that ran and drove last week, I am offering them as cores for rebuilding.

And I'm guessing they've been rebuilt previously in the last 50+ years - some are stamped "LS" - I've been told that means they went through "Lone Star" in Texas - but I can't be sure, sorry.

Also, there's a special treat on one of them - one (dark, unpainted one in the photos) has a second design half casting - 5452281 from 1967 to 1971. Pistons look newer.

See photos. Lots below for the whole picture.

Four calipers - two fronts, left & right and two rears, left & right / eight halves available here - off of the same car. Includes the pins and very serviceable (IMO) pads - they were recently removed by a local shop.

These are complete set for one car with pistons, pins, and pads as shown.

I'm also including the flex and hard lines that came with them.

There's a bit of fluid still on them and the silver paint is soft; I'm draining them as best as I can.

These are heavy.

PM or post with questions as always, thanks Friends.
Anthony

I also have the rotors off of this same car posted here, for cheap:

https://www.yenko.net/forum/showthread.php?p=1659813

Cheers friends,
Anthony

No pads anymore. Plus shipping.

Last call before I dump them at next swap meet.

Cheers.