The Supercar Registry

The Supercar Registry (https://www.yenko.net/forum/index.php)
-   Technical & Restoration (https://www.yenko.net/forum/forumdisplay.php?f=86)
-   -   Carb Restoration recommendations ? (https://www.yenko.net/forum/showthread.php?t=70916)

Charley Lillard 05-13-2002 03:07 PM

Carb Restoration recommendations ?
 
Looking for recommendations on who to have restore a Holley carb. I want more than just a Cosmetic job. I want it to work right also.

FESTIVAL78 05-13-2002 07:01 PM

Re: Carb Restoration recommendations ?
 
The Holley Custom shop is good. Call Jerry MacNeish too. The Holley shop does Q-Jets too F.Y.I.

T Billigen 05-13-2002 08:41 PM

Re: Carb Restoration recommendations ?
 
Does anyone have Woodruff's phone number?

Charley Lillard 05-13-2002 09:56 PM

Re: Carb Restoration recommendations ?
 
The # I have for Woodruff is 330-799-9479.

T Billigen 05-13-2002 10:39 PM

Re: Carb Restoration recommendations ?
 
Thanks, Charley

69L89396 05-14-2002 03:22 AM

Re: Carb Restoration recommendations ?
 
Chicago Corvette Supply does a nice job also. They even test it on an engine for no extra charge. The finish they use is the same as the factory.

copo69 05-14-2002 05:03 AM

Re: Carb Restoration recommendations ?
 
Bob Kunz

micky69396 05-14-2002 05:11 AM

Re: Carb Restoration recommendations ?
 
Kunz or Craig Woodruff

SS427 05-14-2002 05:17 AM

Re: Carb Restoration recommendations ?
 
Those are the best two and there is also Holley carb shop. Just don't send them small pieces such as air cleaner studs, carb studs/nuts, fuel lines, etc. You may not get them back. Also specify needing exact restoration. I got a green choke cam back and my perfect white one was gone???? They took care of it all in the end however.

[Edited by SS427 (05-13-2002 at 12:17 PM).]

IRONCLAD 05-14-2002 04:11 PM

Re: Carb Restoration recommendations ?
 
Does anyone know what buiness name Bob Kunz and Craig Woodruff are associated with?
I looked them up on the Internet without success. I have been trying to get my Holley 3160 restored and have called Holley Custom Shop repeadedly without a callback so I finally wrote them. They responded as to the rebuild and refinishing but could not do dyno-jetting nor install my gear drive injector. I am wondering if either of these gentlemen could do this? Thanks for any assistance in this matter.



All times are GMT. The time now is 03:14 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.


O Garage vBulletin Plugins by Drive Thru Online, Inc.