67 Z small journal crank
 

looking for the small journal steel crank for a 67MO block.
Also need pink rods and wristpins or whatever you have to complete a shortblock.

Re: 67 Z small journal crank
 

I have a few small block cranks here I can check for you. Is there a casting number that I should look for?
Rick

Re: 67 Z small journal crank
 

[ QUOTE ]
looking for the small journal steel crank for a 67MO block.
Also need pink rods and wristpins or whatever you have to complete a shortblock.

[/ QUOTE ] A clean steel 283 crank will do the trick. A little easier to obtain and a little cheaper. Pretty much the same. https://www.yenko.net/ubbthreads/imag...ins/3gears.gif

Re: 67 Z small journal crank
 

Ok Ron, so which 67 Z28 did you end up buying? https://www.yenko.net/ubbthreads/imag...lins/beers.gif

Re: 67 Z small journal crank
 

[ QUOTE ]
Ok Ron, so which 67 Z28 did you end up buying? https://www.yenko.net/ubbthreads/imag...lins/beers.gif

[/ QUOTE ]
Jeff,I got my old Z back! It was deliverd tues.Its been 20 yrs and the paint still looks the same except for a few stone chips in front.Now the fun begins,looking for some parts to complete a spare 302 block that was given with the purchase.im going to clean it up a bit,engine compartment needs attention and drivetrain needs detailing before the big 40th anniversary at carlisle.So im looking for some parts to clean her up a little. https://www.yenko.net/ubbthreads/imag...mlins/grin.gif

Re: 67 Z small journal crank
 

I figured you would wear him down eventually. That's cool you got back your old 67 Z28! Car still looks pretty sweet from the pictures you sent.

Re: 67 Z small journal crank
 

[ QUOTE ]
I figured you would wear him down eventually. That's cool you got back your old 67 Z28! Car still looks pretty sweet from the pictures you sent.

[/ QUOTE ]
Thanks jeff,im takeing the engine out tomorrow,got it ready to pull today and should be easy to do.looking foreward to getting it looking good!

Re: 67 Z small journal crank
 

[ QUOTE ]
I have a few small block cranks here I can check for you. Is there a casting number that I should look for?
Rick

[/ QUOTE ]
Rick im looking for a small journal steel crank,part #3917265.lmk thanks Ron

Re: 67 Z small journal crank
 

[ QUOTE ]
I figured you would wear him down eventually. That's cool you got back your old 67 Z28! Car still looks pretty sweet from the pictures you sent.

[/ QUOTE ]here is a pic,wouldnt be nice not to share some pics with everyone
http://i96.photobucket.com/albums/l1...1/P9290012.jpg

Re: 67 Z small journal crank
 

another,other side.
http://i96.photobucket.com/albums/l1...1/P9290011.jpg