Drain plugs on floors
 

Does anyone know if there are two different thicknesses of drain plugs for the floors? I think the ones used in the trunk were a different thickness vs. the ones used inside the car.

Re: Drain plugs on floors
 

Is this for the 69?

Re: Drain plugs on floors
 

Yep.

Re: Drain plugs on floors
 

I will pull the ones that I have out and check for you.

Re: Drain plugs on floors
 

Cool.

Re: Drain plugs on floors
 

What is a good source for correct drain plugs? Should they be galvanized?

Thanks

Re: Drain plugs on floors
 

All six are the same and shoud be galvanized, at least on Camaro.

Re: Drain plugs on floors
 

Camaro or Nova no difference in thickness. The repo ones they sell today are thicker. They are a galvinized finish. Some have dates, some do not. I just re-installed the original ones from my Nova yesterday, All pulled from the original green, {yes green} seam sealer. None had dates on an April 69' car. We just prepped Frans 69' Nova today, a January 69' car, all had dates and the same green seam sealer. I have also seen non dated and dated plugs on the same car. They are typically installed with this high side up, but I have seen cars with one or two installed upside down...BKH

Re: Drain plugs on floors
 

Good stuff Brian. What finish is on the original ones from the Nova you discussed above? Did you refinish them?

Any photos?

Thanks!

Re: Drain plugs on floors
 

The plugs are gslvinized in all plugs I have observed..BKH