View Single Post
  #46  
Old 08-05-2017, 12:37 PM
sixt9rsx33 sixt9rsx33 is offline
Yenko Contributing Member
 
Join Date: Jul 2008
Location: NC
Posts: 1,319
Thanks: 51
Thanked 592 Times in 168 Posts
Default Charger RT Resto

I have not posted in sometime. I am still waiting on the suspension resto....tick tock...tick tock....The engine is about complete. Very excited about this build. Nothing over the top just fairly stock with an emphasis on the heads to produce nice low end torque for fun driveability and good burnouts!

The rear tailpain trim is all original just removed polished and screwed back on the car. So nice to have a rust free car Same story with wheel well trim. Polished and screwed it right back in the factory holes.

The driveshaft was soaked in a tube of Evap o rust pulled it out and there was this white square painted on the tube. Not sure what that means. I painted it back on. There were two other areas that appeared to have paint on the shaft but apparently the evap o rust removed that paint during the processI am still researching this and hopefully will figure out the other colors so I can reapply.

Today will install the heater box, and a few more items under the hood. Still waiting on a few trinkets under the hood.
Attached Images
 
__________________
65 Corvette Coupe L78
67 427/390 Vette Coupe unrestored
67 L-79 Vette roadster (Top Flight)
69 L71 Roadster Survivor
69 L46 Roadster Survivor (Sold)
69 Z/28 RS (Sold)
69 Dodge Charger R/T
70 W30 442 Auto Air Survivor
2016 Z06 Coupe M7
70 AAR Cuda (Sold)
69 L78 Chevelle (Sold)
Reply With Quote