I'm not sure many know this, but I'm going to enter my car in a small, local event called the Muscle Car and Corvette Nationals in Chicago.
This small, unknown show, has really been gaining popularity and I figured I'd bring my car all the way from Texas just for the heck of it
. No awards or press or anything....just a few cool cars in a room.
So with that said, here's some details I did on the Bee.
This first one shows the block bore size markings that were noted each cylinder to ensure the builder knew what size piston in relation to the bore side to get. These were done on the bare block then the hemi orange paint was sprayed over that. The survivor Bee I have pictured, really shows how thin the factory engine paint was since it's all but worn off of this side of the block.
Cheers
Dave