Been soaking some parts in this Walters CB-100 parts cleaner and things are looking much better. The original fuel and brake line clips look like they were blue and now I can see the original stamps and sizing with the black paint removed. Bolts will clean up a bit better and and are now soaking in Evapo-rust. I cut the crappy exhaust system off and that gave me a better look at all the floors and a clear view of the drive shaft. Found the orange/white stripes right were they are supposed to be but was it was tough holding the tape, work light and camera at the same time so this was the best shot I could get for now. Floors are real nice and can now be properly cleaned. Wife's B-Day today...gotta go spend some time with her and stay out of the penalty box so hopefully more tomorrow...
Clips after coming out of the wash.
Cleaned some other parts up as well.
Found the driveshaft stripes. Orange & White
They measured about 13" back from the center of the front u-joint
Here's a clear look at the front floors.
And a view from the back once the exhaust was dropped
Grey primer under the hanger brackets
What is this bracket on the inside of the frame rail for? Exhaust bracket for a base model that's always there?