[Lynn]

Got the door picked up on the 21st. Left right after the inspector left. One of the projects the inspector gave me was to nail metal strapping from the sill plate all the way up over the door header. Had to run to the home center on Tuesday the 21st, and luckily they had what I was looking for.

Jan. 22. Started nailing the metal strapping. Fortunately, I got help from my brother and my good friend Greg, along with his wife Sherryl. Greg has a fork lift. No way I am getting that door up there without a fork lift. It weighs over 500 pounds. Greg planned on showing up at 2 with the fork lift. It was crunch time (and both of my shoulders were doing a lot of "crunching" by now... after all, there is no cartelage in either one).

My brother came over in the morning, and he and I started putting up the OSB on the inside frame around the door opening. Meanwhile Sherri is uncrating the door. I should have downloaded instructions so I could read them before hand. Oh well.

Just as we were getting the supports mounted to the header, Greg shows up with the fork lift. He is a magician. Got it right up there on the first try, centered perfectly. From there it is just a matter of bolting everything in place. Greg had the fork lift back on the trailer and was headed home in about an hour.

I still haven't put the weather stripping on, and still haven't removed that little bit of dilapidated wall on the West end of the door way. From the outside, you can't even tell I have a roll up door yet. Still have to take the old one off, and remove that wall. But, I am not going to do that until we have some good weather. Boy, was I ready for a few days off when I had my surgery... the next day.