View Single Post
  #10  
Old 09-18-2020, 04:01 AM
firstgenaddict's Avatar
firstgenaddict firstgenaddict is offline
Yenko Contributing Member
 
Join Date: Jul 2001
Location: Greenville, South Carolina
Posts: 5,596
Thanks: 161
Thanked 949 Times in 459 Posts
Default

The hopper on top is too large to make it useful in and around wheel arches trunks etc. - so I took an ever coat undercoat can lid cut the top out soldered it to a short length of tube which I could then affix to the gun using a hose clamp/ this is the same way the original hopper is attached. A short length of rubber hose may work as well..
A HF popcorn gun was $25 so I figured whats the worst that can happen?

With this you are able to screw an evercoat can inverted onto the top... makes it gravity fed, if not you would have to pressurize the pot, it dries harder than the OEM however looks as close as I can find.

The final thing I did was getting picky with the spray pattern and on the the smallest tip I slotted the hole and ground a taper to the slot on the rear so it would shoot less of a round pattern and more of a bar pattern - I have a new sample sheet with those tests and air pressures noted, but I don't have any photos yet.
BTW top row middle was correct...
__________________
~JAG~
NCRS#65120
68 GTO HO 4 spd Alpine Blue /Parchment 2 owner car
#21783 71 Corvette LT1 45k miles Orig paint - Brandshatch Green - National Top Flight - last known 71 LT1 built.
71 Corvette LT1 42k miles Original paint - Black - black leather - only black LT1 known to exist.
NUMEROUS Lemans blue Camaros,
Monza Red and Daytona Yellow Corvettes
& a Chevelle or two...
Survivors, restored cars, & other photos
https://picasaweb.google.com/lh/myphotos

Last edited by firstgenaddict; 09-18-2020 at 04:03 AM.
Reply With Quote
The Following 3 Users Say Thank You to firstgenaddict For This Useful Post:
L78_Nova (09-18-2020), NorCam (09-18-2020), X66 714 (09-18-2020)