No, I put it on the top bunk of the 4 post to nap for the winter now. The yoke looked a little rough when I swapped the rear axles before SCR, but it's been in there for several years and 2,000 miles before the swap. The snapped off section rotates easily by hand on the yoke now too. I did drive the car a short distance after the swap and felt a vibration then too. Probably should have left the car home at that point, but you know how that goes. Must be something in the axle ?? It all looked good when I changed the axle seals. Front u-joint is the same, I had to install a conversion joint in the back for the larger axle yoke and that seemed to go fine too.
__________________
Mitch
1970 Chevelle SS
1966 Chevelle SS
1967 Camaro ss/rs
1938 Business coupe, street rod
2000 FXSTS, original owner, 13k miles
|