Quote:
Originally Posted by DougsL78
Thanks Tom, appreciate it…. It’s that one measurement from the marker bezel to the edge of the quarter that I need to verify - if it’s in the right spot I can triangulate with your measurements of the emblem.
I’d hate to finish the car and have the marker light nearly an inch forward of where it should be (note, I will be weirdly relieved nearly but still annoyed if my marker light on my 69 is an inch further back than it should be.. )
|
Just so I understand...
you want the measurement from the rear edge of the bezel to the edge of the quarter...correct..?? I will try to get it this weekend.
I still think it would be good to get a comparison from a couple of other places. I'm sure one of the sheet metal providers would help with the measurements...the image below is a Goodmark part...lots of folks sell them. That way you get the exact dimensions for the hole.
tew