Well, I got to got to FL for 2 weeks, but that's about 2 months short for avoiding the cold up here.
Anyway, back on the Camaro. After agonizing for days/hours over the fit and alignment of the truck floor/tail panel brace and the tail panel and quarter fit, I finally just said it's about as perfect as I can get it. I prepped and got it welded on.
Drill screws and clamps gets it tight to the trunk floor and frame rails/tank braces.
I'm going to spot weld the top flange to the trunk floor to avoid needing to dress welds and hide them with sealer. Only issue is, my spot welder is at work and I'm not motivated enough to make a 60 mile round trip to fetch it this weekend. I'll get it home next week, as I work Mon-Wed.
