View Single Post
  #5  
Old 06-30-2019, 08:49 PM
69L78's Avatar
69L78 69L78 is offline
Senior Member
 
Join Date: Dec 2003
Location: PA
Posts: 1,746
Thanks: 2
Thanked 90 Times in 49 Posts
Default

Quote:
Originally Posted by bergy View Post
Can't help with the part numbers, but my understanding has always been that the "oval" valve stem cutout was the only factory installed design for 15" trim rings in 1969. I've attached a picture of a survivor trim ring. The "racetrack" cutout (your pictures) is not a factory installed design. Skip (and you) know a heck of a lot about these cars though - so I could stand corrected. Good info.
Bruce, You are correct on the valve stem hole, I should have explained better, Skip's Z has what I believe is the 2nd design with the fingers all the way around to grab the wheel as shown in my pics, and the 3rd design I think has the inside 4 clips with the 2 sharp barbs on each one. I did not get a pic of Skip's valve stem hole.
Reply With Quote