Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
|
|
|
Thread Tools | Display Modes |
|
#1
02-16-2006, 05:49 AM
|
||||
|
||||
1970 Camaro Rear Bumper Guard
I'm in need of the two bolts and washers that hold the bottom of the bumper guards to the rear end panel on my '70 Z28. Thanks.
|
|
#2
02-17-2006, 01:53 AM
|
|||
|
|||
|
Re: 1970 Camaro Rear Bumper Guard
This is one thats done wrong a lot, the bolts look way to small for the brackets. S B C are the originals on my car, not sure how correct you want to be.
__________________
Jack Seymour 1970 Z28 Hugger Orange 20K Mile Survivor
|
|
#5
02-17-2006, 03:44 AM
|
|||
|
|||
|
Re: 1970 Camaro Rear Bumper Guard
www.amkproducts.com has similar if not the same 1/4"X 1" Bolt. I have seen a different head marking than Jack's above picture....so long as some G.M. headmark would be OK!
WELLNUT is/was brand of Valance nut of which AMK has on page 70 of catalog, but not sure if O.E.M. Washer useage appears to have been improvised at factory, as not captured or anything special
__________________
Chuck Sharin [email protected] Auburn,WA (30 miles South of Seattle) 70 Camaro R/S Z-28, L-78, R/S SS 69 Camaro COPO "recreation"
|
|
#6
02-17-2006, 03:55 AM
|
|||
|
|||
|
Re: 1970 Camaro Rear Bumper Guard
They are 1/4" and not 5/16"s ?
|
|
#7
02-19-2006, 05:48 AM
|
|||
|
|||
|
Re: 1970 Camaro Rear Bumper Guard
47Hammer; Nice looking Car.
__________________
Kentucky Gold 70 SS/RS L78. 81 Z/28 Silver/Silver Int 09 G8/GXP #992 98 Pontiac GTP Daytona Pace Car #605 90 Olds Touring Sedan SUPRCHRGD L32 83 El Camino
|
|
#9
02-24-2006, 01:09 AM
|
|||
|
|||
|
Re: 1970 Camaro Rear Bumper Guard
No self tapping bolts used, rear valance has a 1/4-20 (coarse) Nutsert on my car. I have seen cars with and without a black plastic or hard rubber washer against the paint. Unsure about this detail but no self tappers I'm quite positive.
|
|
#10
02-24-2006, 07:53 AM
|
||||
|
||||
|
Re: 1970 Camaro Rear Bumper Guard
So what do ya do, drill the valance?
 It looks like you can't get a nut behind the panel.(talk about a nut behind the wheel)  I was told by a guy that ownes a few second gen cars that he uses self tapping. No wonder every other '70 or second gen Camaro has no rear bumper brackets... I really don't want in to be a mickey mouse deal. What a pain in the backside this has become. Thanks for the comments guys. 
|
|
|
|
Linear Mode
