Go Back   The Supercar Registry > General Discussion > Lounge


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 01-20-2020, 02:56 AM
Lynn Lynn is offline
Yenko Contributing Member
 
Join Date: Feb 2005
Location: Oklahoma
Posts: 7,764
Thanks: 90
Thanked 3,569 Times in 1,505 Posts
Default

Finally, in October, the new floor was poured. Took a lot of prep to get it here.

Pretty darn level for being a fairly large area without being able to drive pins. I specified no pins, as they would compromise the vapor barrier. New floor is 45 wide, 25 deep.

It is very level for 20 feet, then a gentle 5 foot slope to the existing floor on the lower level. Space for the gantry crane, welders, sandblast cabinet, grinder, etc. Even have room to park a couple of cars well out of the work area. That way, if I run into a snag on one car, I can roll it over to the side, and still use the lift and flats on other projects.

Still needed to contend with that big 6 foot by 6 foot square hole in the floor with a well in it.
Attached Images
    
__________________
Don't believe everything you read on the internet ... Ben Franklin
Reply With Quote
The Following 2 Users Say Thank You to Lynn For This Useful Post:
PeteLeathersac (01-20-2020), scuncio (02-04-2020)
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 09:56 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.

O Garage vBulletin Plugins by Drive Thru Online, Inc.