Muncie Input shaft Course 10 Spline 26 Tooth Identification M20 or M22 ?

Home: Goto Homepage.
Subscribed: See all threads you’ve posted in or started.
Today's Posts: Posts made today. Bold = unread.
New Posts: Shows all unread posts since last visit.
New Thread: Newest threads by creation time.

rszmjt · #5 04-04-2022, 02:32 PM

I dont think thats a Muncie 4 speed input, see the small protruding register on the front of the input just in front of the in mesh teeth? notice it has a small oiling hole? Muncies did not use this, also the machined register for the main shaft in the back of input appears too small to accept a Muncie caged input roller bearing assembly, it kinda resembles a Borg T10 design in which the rollers were individual stacked. I think its a aftermarket 9310 input.
Can you post a better larger picture of part number?

The Following User Says Thank You to rszmjt For This Useful Post:
COPO (04-04-2022)

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.