What cam would you run in a day 2 69 Z28

NorCam · #1 10-24-2019, 01:37 PM

Here is Tim's garden tractor come next summer...

**Steve Shauger** · #2 10-24-2019, 02:24 PM

I went with a Comp Cams grind selection that was based on my engine displacement, compression, and rear ratio. When done with modifications roller rockers , headers and bored 40 over, the engine put out 409hp @ 7050rpm and 373lb-ft of torque. It's a flat tappet cam. The modern dual pattern and aggressive ramp cam allow for both HP & Torque. I have the grind card and will send it to you. It has a nice lope but I could care less about the idle sound, the drivability & performance is what I care about.

**napa68** · #3 10-24-2019, 08:33 PM

Quote:

Originally Posted by norcam

here is tim's garden tractor come next summer...

lmao

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

The Following 3 Users Say Thank You to Steve Shauger For This Useful Post:
NorCam (10-25-2019), rlw68 (10-24-2019), Tom Hartman (10-26-2019)

The Following User Says Thank You to napa68 For This Useful Post:
Jims69z28 (10-25-2019)

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.