Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
#1
08-24-2020, 03:26 PM
|
|||
|
|||
Cool Vintage Header ID
Looking to ID this set of headers. There are no numbers stamped on the flanges or anywhere else I can see. They are orange and appears to be original paint. They were barely used looking inside them. Thanks, Larry 5203492337
SBC bolt pattern Last edited by lbnaz; 08-24-2020 at 05:00 PM. 
|
|
#2
08-24-2020, 04:43 PM
|
||||
|
||||
|
I'd like to hear what those sound like on a car.
__________________
Freddie 1969 Camaro RS/SS396 (427) 4 speed
|
|
#4
08-25-2020, 10:45 PM
|
|||
|
|||
|
Mounted them on a sbc 350 for visual. They fit angle plug heads. Any idea of the brand. There the same orange color as MT Headers. Thanks, Larry
|
| The Following User Says Thank You to lbnaz For This Useful Post: | ||
PeteLeathersac (08-25-2020) | ||
|
#5
08-25-2020, 11:10 PM
|
||||
|
||||
|
I wonder if they might be from an old NASCAR team? Maybe they weren't a factory built set, but a custom made set.
__________________
Freddie 1969 Camaro RS/SS396 (427) 4 speed
|
| The Following 5 Users Say Thank You to big gear head For This Useful Post: | ||
earntaz (08-25-2020), lbnaz (08-26-2020), Lee Stewart (11-11-2020), markinnaples (08-26-2020), PeteLeathersac (08-25-2020) | ||
|
#6
08-25-2020, 11:47 PM
|
||||
|
||||
|
'
Or old road racer w/ extra clearance of the dual exit, where's Jon M?  Note squared tubes at head flange also flat top edge when seeking maker as most are round w/ indents in top edge. Super cool whatever they are!  ~ Pete .
__________________
I like real cars best...especially the REAL real ones!
|
| The Following User Says Thank You to PeteLeathersac For This Useful Post: | ||
lbnaz (08-26-2020) | ||
|
#7
08-27-2020, 02:38 AM
|
||||
|
||||
|
Those have to be custom made headers not something from a catalog. I'm sure they are for a race car and the ends are done spread out like that for ground clearance and to keep them tucked up close to the floor. That number 8 tube goes back farther than most stock firewalls I've ever seen on a Chevy so again that makes me think of a race car with an altered firewall. Just my 2 cents worth.
|
| The Following 3 Users Say Thank You to 1967Z28 For This Useful Post: | ||
|
#8
11-10-2020, 10:28 PM
|
|||
|
|||
|
Still haven't found out about these headers. It turns out that this motor that was in that 70Z race car is a Traco built 355. It is stamped on the front of each head Traco 744. The heads are Brownfield aluminum no bolt holes for acc. Researching Traco online they have a lot of race and engine building history. Pretty cool piece. Larry
|
| The Following 3 Users Say Thank You to lbnaz For This Useful Post: | ||
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
