Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Members List | Calendar | Become a Paid Member | Search | Today's Posts | Mark Forums Read |
|
|
|
Thread Tools | Display Modes |
|
|
|
#1
05-02-2022, 01:48 AM
|
|||
|
|||
Side Rocker Mouldings
I used NOS pieces for the side mouldings. As a piece of advice to avoid issues its best to fill all the holes the factory puts in and place your own. Couple of shots below of the drivers side. I rolled the car out of the garage today to clean things up. Car is finally starting to look really good. Just a piece of unique information comparing 66 to 67. I had original shots of the screws and clips, the screws are #8s of my car. I got confused because over the years I have robbed plenty of the these clips and thought the screws were #10s. Come to find out in the AIM 66 did use a #8 and 67 and I assume later used #10s.
|
| The Following 8 Users Say Thank You to OneStopRestoration For This Useful Post: | ||
67 Nova Boy (07-22-2023), 67since67 (05-02-2022), bobm67 (05-02-2022), dykstra (05-03-2022), L78_Nova (05-02-2022), markinnaples (05-04-2022), olredalert (05-02-2022), scuncio (07-19-2023) | ||
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
