68 L78 Nova - resto journey

[chevyman0429]

For sure looking to watch this build!

[DougsL78]

Actually guys, I need help with something.

The project car has early GM replacement quarters and the placement of the rear marker lights I need to verify as they are pretty crudely cut (let alone the Nova emblem placement above it but that will be step 2...)

I have scoured the 68 AIM and Chassis manual and I cannot for the life of me any references on how to locate proper position of the marker and/or emblem … I’m looking to drill appropriate holes on the replacement quarters.

As a starting point I will look to confirm a proper location of the rear marker light. I think the 68 and 69 position should be the same… but want to verify. I have measured the distance (with a soft tape) from the top rear of the bezel to the rear edge of the fender on the project 68 and my completed 69. .

See picture below. On the 68 it is 7” from top bezel edge to edge of fender. On my 69 car it’s 6 1/8”. Seems Like too large of a difference to be left to factory variance.
Can anyone else take a quick measurement on a 68 or 69 like I did in the picture below?

[WILMASBOYL78]

Doug...

Thought I would jump in to try and help.

Here is the info I provided previously...I had the 68 car out the other day and re-checked.

5 5/8” from bottom of the Nova emblem to the top of the marker lite bezel

5 ¾ “ form the edge of the ‘A’ in Nova to rear edge of the quarter….

6 .5 “ top of the ‘N’ to the top edge of the quarter…

photos attached....

68 and 69 position is the same. I know there are some members here with 69's...Sammy and Joe come to mind. Maybe they can confirm measurements.

Another option would be to check with one of the sheet metal suppliers and ask them if they would give you some measurements...might help.

Hope this helps.

Tom