1957 Chevy Front Spindle Washer

[Lynn]

Kind of an odd ball request.

Any Tri Five owners here with a stash of parts?

Need one spindle washer. OD is 1 and 15/16. ID is 3/4. Mic says 1.940 and .758.

Let me know if you have one.

[Too Many Projects]

Originally Posted by Lynn

Kind of an odd ball request.

Any Tri Five owners here with a stash of parts?

Need one spindle washer. OD is 1 and 15/16. ID is 3/4. Mic says 1.940 and .758.

Let me know if you have one.

Does that have a tang to fit in the slot of the spindle to prevent it from turning ?

[Lynn]

Yes. The 3/4 inch ID does not take into account the tang.

[Stefano]

I'll check.

[Stefano]

I found a couple. Email shipping address to [email protected]

[Too Many Projects]

Good deal that Stefano found some. I would have bet I had at least 1 in my 1970's parts box, but no.

[Lynn]

Stephano: you da man. Sent an email.

Mitch: I had nothing in my stash either. I believe this same washer was used up until 62.

[Stefano]

I had just cut the front part of a frame off a '57 that will get a NicKey Straight Axle Kit. So I knew right where they were at. Hope that it works out for you. I just saw the thread on your '57 today. Very kool car, I like it a lot. Did that Old guy from Laharpe with the black LS6 ever start a thread on his OLD '57?

[big gear head]

Originally Posted by Stefano

I had just cut the front part of a frame off a '57 that will get a NicKey Straight Axle Kit. So I knew right where they were at. Hope that it works out for you. I just saw the thread on your '57 today. Very kool car, I like it a lot. Did that Old guy from Laharpe with the black LS6 ever start a thread on his OLD '57?

He's posting pictures of it on Facebook.