Neat Machining Video - Page 3

Home: Goto Homepage.
Subscribed: See all threads you’ve posted in or started.
Today's Posts: Posts made today. Bold = unread.
New Posts: Shows all unread posts since last visit.
New Thread: Newest threads by creation time.

nuch_ss396 · #21 10-12-2007, 04:58 AM

Yes Ken, the coating(s) you are referring to are actually
only a few microns thick. Normally, these coatings embed
partially into the substrate of the tool steel ( carbide ).
The faster you run them, the better they cut.
Sounds contradictory, but it's true.

Steve

gwawa · #22 10-12-2007, 04:59 AM

In case you didn't look closely, this is just one of the lug-nuts off Ken's Biscayne he recently completed....

**Xplantdad** · #23 10-12-2007, 06:42 AM

[ QUOTE ]
In case you didn't look closely, this is just one of the lug-nuts off Ken's Biscayne he recently completed....

[/ QUOTE ]

Too funny

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.