Drive Shaft Needed

**bergy** · #1 01-27-2023, 08:04 AM

Looking for a nice, correct drive shaft for my 67 BB automatic Camaro. According to CRG - needs to be 49.96" long (eye center to eye center) and the yokes should be in line (not clocked)

**j1m68** · #2 01-29-2023, 01:08 AM

I have one off a 68 Camaro 396 4 spd car. It measures 50.5" eye center to eye center. Joints are in line also.

**bergy** · #3 01-29-2023, 07:31 AM

Thanks for replying. In addition to the length, the yokes are different on that one. Any others out there?

**Salvatore** · #4 01-29-2023, 01:04 PM

Check with Heartbeat City or Bob Harris. Maybe even Fred Schempp or Dave Valentin
has something like that.

**X66 714** · #5 01-29-2023, 01:23 PM

Quote:

Originally Posted by bergy

Thanks for replying. In addition to the length, the yokes are different on that one. Any others out there?

It sounds like you require the drive shaft with the injected u-joint locks (Saginaw) instead of the snap ring type (Spicer), correct....Joe

**j1m68** · #6 01-29-2023, 03:14 PM

Yes you are correct about the yoke also. Mine has the 1 1/2" diameter one.

**camarodude67** · #7 01-29-2023, 03:32 PM

I have a 1967 Camaro Gm driveshaft from a L78 but is clocked if that is the correct terminology.

**bergy** · #8 01-29-2023, 06:55 PM

Yes - injected U joints Joe. I have the original, but it's not in great shape. Hoping to find a really nice one, or may have to re-tube what I have :-(

**bergy** · #9 02-06-2023, 12:12 PM

Anybody have one? I've seen some with the yokes actually clocked, but the ends have to be nyloc type. Any out there?

**luv2sixty9** · #10 02-08-2023, 09:16 PM

I should have you covered. See you on Tuesday. Dave

The Following User Says Thank You to bergy For This Useful Post:
X66 714 (01-29-2023)