|
Register | Album Gallery | Thread Gallery | FAQ | Members List | Calendar | Become a Paid Member | Search | Today's Posts | Mark Forums Read |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
WTB Holley Manifold Studs
Need up to (4). Factory or after market with same thread lead and length. 5/16-18 & 24. Looks like cad finish. PM or e-mail. [email protected]
|
#2
|
|||
|
|||
Intake studs
I have NOS ones #333959 that replaced #3967475 if you are interested....
__________________
1970 Camaro 1972 Z28, 1973 Corvette L82,4 speed 1974 Z28 LT,M20,AC,18k Original Miles 2007 Ford Shelby GT500 40th Anniversary |
#3
|
|||
|
|||
Thanks for the offer. I previously looked at cutting down the lead on a 333959, but doing so leaves the thread short. AMK sells a stud that can possibly be modified to the correct length. However, before I go that route, I'll see if anyone has any like those in the pics.
|
#4
|
|||
|
|||
look up member Enoch...i saw some he had listed not too long ago
__________________
Mark |
#5
|
|||
|
|||
Thanks for the reply. I've been watching Rich's posts for a while. He did have a set that were for I believe an early Vette. They were shorter than the ones I need.
|
#6
|
|||
|
|||
Intake studs
Here is a few updated pictures with digital calipers....
__________________
1970 Camaro 1972 Z28, 1973 Corvette L82,4 speed 1974 Z28 LT,M20,AC,18k Original Miles 2007 Ford Shelby GT500 40th Anniversary |
#7
|
|||
|
|||
I'm not sure what your application is but I think these may be correct for you. These are off of a 1971-1972 3959594 LT-1 intake. I planned on reinstalling them on the intake but I would be open to selling them.
Jason |
#8
|
|||
|
|||
pm sent
|
Thread Tools | |
Display Modes | |
|
|