|
Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Original 2-1/4" exhaust clamps
So here is one I've never really looked into over the years. And came across these in 1 of my old bins that had a lot of very original 1st Gen. Camaro parts. My question would be are these assembly line exhaust clamps. They have a couple of interesting features which are typical of the time period with Oh stamped on the middle of the lower brace, similar to transmission U joint straps and the U bolts have the flat stamping on the top Similar to the original U bolts on the rear ends. Any help would be appreciated. Thanks also with these have flanged nuts or just nuts and lock washers?
|
#2
|
||||
|
||||
I believe they were used in the over axle to cross flow muffler which is a 2.25 they also look like the tailpipe extension clamp for a vette.
__________________
~JAG~ NCRS#65120 68 GTO HO 4 spd Alpine Blue /Parchment 2 owner car #21783 71 Corvette LT1 45k miles Orig paint - Brandshatch Green - National Top Flight - last known 71 LT1 built. 71 Corvette LT1 42k miles Original paint - Black - black leather - only black LT1 known to exist. NUMEROUS Lemans blue Camaros, Monza Red and Daytona Yellow Corvettes & a Chevelle or two... Survivors, restored cars, & other photos https://picasaweb.google.com/lh/myphotos |
The Following User Says Thank You to firstgenaddict For This Useful Post: | ||
Enoch (02-20-2020) |
#3
|
|||
|
|||
Thanks, that's what I thought it was 4 was the crossover pipes.
|
|
|