#1
|
||||
|
||||
Stencil Kits
We’re getting closer to paint on the 67 Z. Does anyone have a recommendation on a stencil kit for the stripes?
Thanks Paul |
#2
|
||||
|
||||
|
#3
|
||||
|
||||
Thanks Lee, have you used this kit?
|
#4
|
||||
|
||||
Progress PICS!!!!!
|
#5
|
||||
|
||||
Stencils & Stripes Is who I've used with good success....Joe
__________________
1968 Z/28 Corvette Bronze. Black Hounds Tooth. 02E Los Angeles born 3/13/1968 pnt OO 1969 SS396 Yellow/Yellow 08E Norwood born 8/28/1969 pnt 76E 1970 'cuda Moulin Rouge, 440-6, 4 speed |
The Following User Says Thank You to X66 714 For This Useful Post: | ||
juliosz (10-31-2022) |
#6
|
||||
|
||||
Like Joe, I would recommend Stencils & Stripes in Illinois. I bought their kit for my 69 Z/28 and it was identical to all the original tracings I took from the car's original paint marks. Excellent templates in my opinion.
https://www.stencilsandstripes.com/p.../model/camaro/
__________________
I like solid lifter cars, big cams and cars w/ 3 pedals in them. |
The Following 3 Users Say Thank You to NorCam For This Useful Post: | ||
#7
|
||||
|
||||
This is about three weeks ago. They since primed again and final sanding prior to going back on the rotisserie.
|
The Following 9 Users Say Thank You to juliosz For This Useful Post: | ||
169indy (11-01-2022), 1967Z28 (11-04-2022), Lee Stewart (11-01-2022), napa68 (11-01-2022), NorCam (11-01-2022), olredalert (11-01-2022), PeteLeathersac (11-04-2022), RPOLS3 (11-01-2022), X66 714 (11-01-2022) |
#8
|
|||
|
|||
That is who I used for the stencil kit on my 69 Z, and like Norcam said, it was dead on.
__________________
Don't believe everything you read on the internet ... Ben Franklin |
The Following User Says Thank You to Lynn For This Useful Post: | ||
juliosz (11-01-2022) |
#9
|
||||
|
||||
I have a kit on order from Stencils and Stripes. Many thanks for all of the advice and support from the fine folks on this forum!
|
The Following User Says Thank You to juliosz For This Useful Post: | ||
X66 714 (11-04-2022) |
#10
|
||||
|
||||
The '67-'68 is obviously a little different in the back compared to a '69. I had a Stencils & Stripes kit and found I had to fudge around a little to get it to look accurate and how I wanted it. I did have an original paint '67 Z trunk lid to help get the spacing right. I mounted that lid and masked the filler panel below the rear window and then mounted the lid I was going to use. I then masked that lid following what was above. The original stripes are slightly narrower at the back edge than up toward the window if I remember correctly.
Last edited by 1967Z28; 11-04-2022 at 08:18 PM. |
|
|