|
Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
MSD Distributor - Vintage Look?
On my 74 CJ5 with a 304 V8 I am running a MSD ignition with a black billet MSD distributor. I am not running the cap that goes on top of the distributor and on top of the plug wire boots. (Hate how it looks)
My issue is that I don’t like how the boots are gray and the have the nipples on top. Any other plug wire boots that are black without the nipples out there that I could put on? Thanks fellas....
__________________
Bill O'Brien 1974 Jeep CJ5 - 304 V8, Edelbrock Intake, Holley 650, MSD Ignition, Patriot Headers |
#2
|
|||
|
|||
yes you can buy them with out nipples, a universal kit can come with both sets of boot and you make it the way you want,.,,you can buy black wires, and a little thinner will take all the lettering off...so you can stealth them up..any aftermarket wire kits you can get the boots you want,,you can even buy just boots
__________________
Mark |
#3
|
||||
|
||||
Standered Ignition sells both 7mm & 8mm boots. I just changed mine before MCACN,I am running Taylor wires that have been wiped clean of any ID.
BIG |
#4
|
|||
|
|||
Big, can you post a link to the wire boots you bought?
Thank you!
__________________
Bill O'Brien 1974 Jeep CJ5 - 304 V8, Edelbrock Intake, Holley 650, MSD Ignition, Patriot Headers |
#5
|
||||
|
||||
|
|
|