Intake manifold restoration - Page 2

**Steve Shauger** · #11 11-09-2023, 07:07 PM

Quote:

Originally Posted by ScottG

BBC factory aluminum intake manifold. I would like to get it close to factory appearance. Who and how does it happen? Thanks.

Here's a link to Dave Beem's samples of restored intakes. He does exhaust manifolds and transmission cases as well.

https://www.yenko.net/forum/showthread.php?t=173120

**jeffschevelle** · #12 11-10-2023, 03:36 PM

Rob Walden (at Lamar Walden Motorsports in GA) does fantastic restoration of cast aluminum parts. He can also repair any defect with no signs it was ever touched. Resurfaces all the machined areas as well, if you want.

When you get it back you'll think its a little too shiny, but after it heat cycles on the engine a few times it is exactly what you want!

noumansaeed · #13 11-14-2023, 10:32 AM

Need to visit the closest workshop

The Following 4 Users Say Thank You to jeffschevelle For This Useful Post:
Big Block Bill (11-10-2023), HawkX66 (11-13-2023), napa68 (11-10-2023), olredalert (11-11-2023)