![]() |
#1
|
||||
|
||||
![]()
I'm south until mid-April, parts book is back home. Looking for anyone who could find part numbers circled in red below. Many thanks in advance.
Paul |
#3
|
|||
|
|||
![]()
Here’s the whole page.
|
The Following 2 Users Say Thank You to Rsconv68 For This Useful Post: | ||
juliosz (01-14-2025), PeteLeathersac (01-14-2025) |
#4
|
|||
|
|||
![]() Quote:
#14 is group 10.688 Screw, ventilator division channel to frame part # 4304827 #23 says Screw, vent support to frame N.S. (not serviced) so I'm guessing it's some sort of common screw #24 says Support, Division Channel N.S. (not serviced) included as part of #13 Not much help I'm afraid but maybe some help at least. |
The Following User Says Thank You to Darth For This Useful Post: | ||
juliosz (01-14-2025) |
#5
|
||||
|
||||
![]()
Thanks everyone, much appreciated! I brought my vent window assemblies with me to rebuild and neglected to bring the screws.
|
#6
|
||||
|
||||
![]()
I have the vent windows out of my '67 Camaro. I can remove those fasteners and send them to you to assemble your windows and then send me your fasteners when you get back...
![]()
__________________
Mitch 1970 Chevelle SS 1966 Chevelle SS 1967 Camaro ss/rs 1938 Business coupe, street rod 2000 FXSTS, original owner, 13k miles |
#7
|
||||
|
||||
![]()
Thank you for the generous offer, Mitch. I tried the part numbers on AMK's site and came up empty. If it's not too much trouble for you, could you snap a pic of the fasteners and give me the size and length? Even if I can't get a perfect match, I can get something good enough to assemble then swap to the originals when I get home.
Paul |
#8
|
||||
|
||||
![]()
I'll dig out the windows and remove the fasteners for pics and measurements in the next couple days.
__________________
Mitch 1970 Chevelle SS 1966 Chevelle SS 1967 Camaro ss/rs 1938 Business coupe, street rod 2000 FXSTS, original owner, 13k miles |
#9
|
||||
|
||||
![]()
OK, I found the windows easily, but it took a bit to extricate them from where they were set down over a year ago...
![]() The 2 that hold the lower channel to the frame are not bolts. They have round heads, so I suspect the pic is a general depiction of a fastener. They are 12X24 thread and 1/2" long. The small screw at the top is a common one I see for things like this, but are rather specialized. The head is countersunk and small and the threads are more like a sheetmetal count, as they seem to be 17 TPI. The 16 gauge is just a little too wide. The length is about 5/16".
__________________
Mitch 1970 Chevelle SS 1966 Chevelle SS 1967 Camaro ss/rs 1938 Business coupe, street rod 2000 FXSTS, original owner, 13k miles |
The Following 3 Users Say Thank You to Too Many Projects For This Useful Post: | ||
#10
|
||||
|
||||
![]()
Thank you, Mitch...your help here is invaluable!
|
![]() |
Thread Tools | |
Display Modes | |
|
|