Ryan Weaver's 1969 Olds Cutlass S W31 Club Coupe

[Ryan1969Chevelle]

Front clip metal items are still awaiting powder coating.

I ordered tires from Rusty Small F70-14 Goodyear White stripe bias plys. I am very happy to support someone who contributes to our hobby/passion daily.

I firmed up general pricing and timing with an interior shop. I own various interior pieces so mostly the interior shop will install of course there will be some materials.

I received yet another exciting box-o-fun from Inline Tube... fan clutch, trunk weather strip, hood stops, master cylinder lid, rag
Joint, some fastener kits, clips, etc.

I picked up my rad, beautiful re-cored and ready.

I have to verify one dimension tonight so I can order some more Fusick items... the felt “seals” at four corners of the rad, and a few other goodies.

My driver is full of car parts, I couldn’t take even one passenger..... I better get out there and get organized!

Ryan W31

[Ryan1969Chevelle]

Pictures.

[Lynn]

Really looking forward to seeing this one done Ryan.

[Lynn]

Originally Posted by Ryan1969Chevelle

I need to clean the inside of the front fenders, oven cleaner?

Ryan W31

On my Z, the insides of the inner fenders had a lot of undercoat. I stripped them using a course wire wheel on a 4.5 inch angle grinder. Once the wires start to bend a bit, flip it around but be VERY CAREFUL, as it will really bite for the first few minutes, until they start bending the other direction. Then turn it around again. Lather rinse repeat, or something like that. Sure tears that old dried up undercoat out in a hurry.

[Ryan1969Chevelle]

Originally Posted by Lynn

Really looking forward to seeing this one done Ryan.

That makes two Lynn’s :-)

Al and Lynn Stager are keeping a close eye :-)

Ryan W31

[Ryan1969Chevelle]

Originally Posted by Lynn

On my Z, the insides of the inner fenders had a lot of undercoat. I stripped them using a course wire wheel on a 4.5 inch angle grinder. Once the wires start to bend a bit, flip it around but be VERY CAREFUL, as it will really bite for the first few minutes, until they start bending the other direction. Then turn it around again. Lather rinse repeat, or something like that. Sure tears that old dried up undercoat out in a hurry.

I will gently try some cleaning techniques.

Thanks

Ryan W31

[Ryan1969Chevelle]

Ordered a set of T3 headlights, headed to Dan V for NOCC pick up.

Ordered Fusick plastic/rubber/felt “seals” for around the rad.

Ordered Inline Tube inner fender splash guards..... do they come with staples? They don’t sell them.... where do I get them?

Plus my powdercoating is done so I am racing over to get it before skateboard shopping with the lad :-)

Ryan W31

PS: my “To Purchase” list is getting smaller, I need to introduce the “To Sell” list very shortly.

[olredalert]

----Pretty easy and quick to just make your own staples, Ryan…...Bill S

[Ryan1969Chevelle]

Originally Posted by olredalert

----Pretty easy and quick to just make your own staples, Ryan…...Bill S

A few people have said to make them from 0.041 SS wire or used HD paper clips to make them.

Ryan W31

[Canuck]

Fusick provides the staples with the flaps they sell. I asked for and got extras a few years ago when I needed them.

Paul