Forum: Supercar/Musclecar Discussion
Today, 03:44 PM
|
Replies: 15
Views: 1,235
|
Forum: Day 2 stuff-modified cars
Today, 02:24 PM
|
Replies: 123
Views: 66,465
|
Forum: Supercar/Musclecar Discussion
Today, 01:33 PM
|
Replies: 15
Views: 1,235
69 Z28 Burgundy
Circa 1976-77. My daily driver in the background is the BRG 67 Austin Healey Sprite at that time.
|
Forum: Lounge
Today, 03:41 AM
|
Replies: 17
Views: 1,025
|
Forum: Member's Rides
Today, 12:46 AM
|
Replies: 143
Views: 53,476
|
Forum: In Memoriam
Yesterday, 11:59 PM
|
Replies: 2
Views: 136
Donald Sutherland
Passed at 88.Appeared it a lot of movies.My fav was his part in Kelly's Heroes as Sgt.Oddball.RIP sir.
|
Forum: Chevrolet
Yesterday, 10:21 PM
|
Replies: 9
Views: 644
|
Forum: Pontiac
Yesterday, 07:01 PM
|
Replies: 197
Views: 91,478
|
Forum: Supercar/Musclecar Discussion
Yesterday, 04:41 PM
|
Replies: 15
Views: 1,235
|
Forum: Supercar/Musclecar Discussion
Yesterday, 03:47 PM
|
Replies: 72
Views: 22,174
|
Forum: Supercar/Musclecar Discussion
Yesterday, 12:30 PM
|
Replies: 15
Views: 1,235
|
Forum: Supercar/Musclecar Discussion
Yesterday, 12:10 PM
|
Replies: 15
Views: 1,235
|
Forum: Supercar/Musclecar Discussion
Yesterday, 12:03 PM
|
Replies: 15
Views: 1,235
|
Forum: Fred Gibb Chevrolet
Yesterday, 03:24 AM
|
Replies: 2
Views: 353
ZL-1 #10 engine located
Rebuilt as a 454 and configured for racing, not run. Block was decked, con VIN stamp remains on the side of the block. Has original heads.
Owner would like to see it reunited with the chassis. I...
|
Forum: Technical & Restoration
Yesterday, 02:16 AM
|
Replies: 5
Views: 569
|
Forum: Supercar/Musclecar Discussion
06-19-2024, 11:44 PM
|
Replies: 3
Views: 493
|
Forum: Mopar
06-19-2024, 02:48 PM
|
Replies: 14
Views: 2,948
|
Forum: Mopar
06-19-2024, 02:37 PM
|
Replies: 14
Views: 2,948
Moving on to the engine, it was evident that it...
Moving on to the engine, it was evident that it was filthy, 50+ years of grime, grease and makeshift repairs, it was leaking from every conceivable orifice, but it ran very well, so I decided to put...
|
Forum: Mopar
06-19-2024, 01:46 PM
|
Replies: 14
Views: 2,948
Continuation from the post yesterday. After...
Continuation from the post yesterday. After examining the internals of the trans, everything looked good, so I cleaned it up, replaced the input shaft and output shaft seals and reinstalled the top...
|
Forum: Technical & Restoration
06-19-2024, 01:32 PM
|
Replies: 5
Views: 569
1969 RS/Z28- Correcting Things
1) Installed correct height springs
2) Removed this hideous aftermarket am/fm cassette. Luckily nothing was hacked up when installed. It was a rats nest of wires. There something about removing...
|
Forum: Supercars/Musclecars-For Sale
06-19-2024, 03:58 AM
|
Replies: 9
Views: 3,974
[QUOTE=JQ;1644314]1969 COPO Camaro sold out of...
[QUOTE=JQ;1644314]1969 COPO Camaro sold out of Jim Funston Chevrolet in Detroit Michigan. Original born with 427 motor, CX turbo 400 with console and BE 4:10 rear end. Full rotisserie restoration...
|
Forum: Chevrolet
06-19-2024, 03:46 AM
|
Replies: 9
Views: 644
|
Forum: Chevrolet
06-19-2024, 02:55 AM
|
Replies: 9
Views: 644
Such a shame
This 1960 Bel Air was a daily driver until recently.
A woman drove this car everyday to her work at a hospital here in Fremont Ca.
She would take it for service at this restored gas station down...
|
Forum: L78/L89 specific Forum
06-19-2024, 01:02 AM
|
Replies: 355
Views: 172,413
I went to my local cars and Coffee Father's day...
I went to my local cars and Coffee Father's day and a local photographer took these photos of my car. Luckily where I live there are Cars and Coffee events every weekend year round and I do enjoy my...
|
Forum: Mopar
06-18-2024, 09:23 PM
|
Replies: 14
Views: 2,948
Well, I've been hard at work on this Truck for...
Well, I've been hard at work on this Truck for the past few months. I'll add posts as I get time to show the progress. I was able to fix all of the oil leaks, replaced the timing set, cleaned the...
|