'69 Z, White on White, #s, POP

[enio45]

Steve, if the 6308 moog is slightly lower, what is the recommended one from moog for the original stock height? Any idea?

From a stance - originally built, is the front suppose to have a slight increase higher than the back? I know this is personal preference for what you like, but was just wondering for future reference.

[Steve Shauger]

Originally Posted by enio45

Steve, if the 6308 moog is slightly lower, what is the recommended one from moog for the original stock height? Any idea?

From a stance - originally built, is the front suppose to have a slight increase higher than the back? I know this is personal preference for what you like, but was just wondering for future reference.

I chose this spring because it is close to the factory Z28 and it was recommended. I know there is a 6312, but have no experience.


I will post pictures once I have new tires installed and an alignment.






I had used Eaton for a big block, auto & a/c Pace car. I tried three sets of springs and spoke with them several times, at the end they said "try these". That's when I searched for another supplier (listed in Hemmings)located in Kansas back in 1994. His springs were perfect the first time!


As far as ride heights check the assembly manual, which has dimensions front and rear. I believe the rear is slightly lower....

[rlw68]

Originally Posted by Steve Shauger

I chose this spring because it is close to the factory Z28 and it was recommended. I know there is a 6312, but have no experience.

Hey Steve, the Moog 6308's I just got have a black vinyl coating. Did you repaiint yours or going with bare steel?