69 Z/28 Day II Project (Air Force Brat)

[NorCam]

Sneak a Peek...

I got sidetracked a little tonight and banged in the rear seat so I could see what was going to look like. Also wanted to see if a Lakewood bar would interfere with what's going on here and I think it would kill the pattern on the houndstooth where the rear leg would need to fit in between the seat folds. . Suffice to say...roll bar is out on this one. I have to say though...I am liking the colors here. The seat and the side panels are going to need a little more fitting and tweaking before they are ready to go in for good but it won't be long now.

[day2killa]

Originally Posted by NorCam

Sneak a Peek...

I got sidetracked a little tonight and banged in the rear seat so I could see what was going to look like. Also wanted to see if a Lakewood bar would interfere with what's going on here and I think it would kill the pattern on the houndstooth where the rear leg would need to fit in between the seat folds. . Suffice to say...roll bar is out on this one. I have to say though...I am liking the colors here. The seat and the side panels are going to need a little more fitting and tweaking before they are ready to go in for good but it won't be long now.

i had the same problem with my 3pt roll bar for my chevelle I did not want to ruin an original back seat. so i made a new bar that was just short of going between the seats and put a rubber cap on the end to not hurt the seat. If you look in the car you cannot tell that it isnt attached to the car. Just a thought if you still want the day 2 look of a 3pt.