Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
|
|
Thread Tools | Display Modes |
|
#5
10-14-2021, 11:42 PM
|
|||
|
|||
I also cut a slot in a piece of wood big enough for the wire harness to slide through so the socket sits on top of the wood. Then I used two pieces of metal strips and "C" clamps to hold the housing to the wood. I put a little black strip calk between the housing and socket for a water proof seal. The initial hit was with a ball peen hammer and then I went around the socket with a flat punch to get it tight.
Last edited by mhm1966; 12-31-2021 at 01:54 PM. 
|
| The Following 2 Users Say Thank You to mhm1966 For This Useful Post: | ||
Edgemontvillage (10-19-2021), rlw68 (10-15-2021) | ||
|
|
Threaded Mode