Quote:
Originally Posted by Too Many Projects
Nice vid for help. The tip with the vise grips to pull the radius tight is very important and will help close up trunk lid gap. He already had the tail panel spot welded to the quarter, DON'T do that first. Use the vise grips to pull those panels square and tight to each other first and then check gap. The sequence he did this in won't allow any quarter movement, it only pulls the tail panel out to meet the q-p.
|
I think he already had it set, but was retracing the process for the demo. Jubee has some good metal working content on his channel.
05-26-2022, 07:47 PM
Threaded Mode