Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
|
|
Thread Tools | Display Modes |
|
#5
03-06-2025, 11:03 PM
|
|||
|
|||
In the past I have used a small cut off wheel and a hacksaw blade to completely remove all the plastic from the heater core tubes. With just the aluminum tubes sticking out of the firewall I then slide a heater hose over each tube and clamp. Difficult to see the "tee" setup but possibly move it down the heater hoses and splice in an old fashioned one.
Doc 
|
| The Following 2 Users Say Thank You to Danzo For This Useful Post: | ||
Lynn (03-07-2025), olredalert (03-06-2025) | ||
|
|
Threaded Mode