![]() Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|
Register | Album Gallery | Thread Gallery | FAQ | Community ![]() |
Calendar | Become a Paid Member | Today's Posts | Search |
|
Thread Tools
![]() |
Display Modes
![]() |
|
#24
|
|||
|
|||
![]()
Good point on the length Tim. On my '66 chevelle bench seat, the tunnel mod actually created a slight interference with the center of the seat frame. It's all the way back, since I'm 6'3", and it'll only get tighter moved forward. You're going about this in a comprehensive way, which so many don't. I used an LT1 T56, which added another cost being the $400 conversion flywheel. I was lucky enough to get the clutch master and line with my tranny. You'd also need a new driveline. The speedo is another issue, which is doable on a T56 magnum, but it's not on the standard LT1 based T56, which would necessitate a GPS conversion speedo.
|
The Following User Says Thank You to cheveslakr For This Useful Post: | ||
napa68 (05-13-2025) |
|
|