Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
|
|
Thread Tools | Display Modes |
|
#11
03-30-2021, 10:22 PM
|
||||
|
||||
As usual, it's ALL looking great. I noticed in going back over the last few pages that your heater core looks questionable. Are you having it pressure tested and cleaned before install ?
The bolt holes off center in the perches was a GM thing. I ran into the same issue on an '80 Trans Am at work a couple months ago. I can't turn the upper nuts to adjust the tension of the bottom nuts without taking them out of the perch and guessing how much to move them down. Time consuming PITA and it's waiting to get on a drive on lift to tighten the spring ends and set the snubber height under full weight.
__________________
Mitch 1970 Chevelle SS 1966 Chevelle SS 1967 Camaro ss/rs 1938 Business coupe, street rod 2000 FXSTS, original owner, 13k miles 
|
| The Following User Says Thank You to Too Many Projects For This Useful Post: | ||
Chuck_Burg (03-30-2021) | ||
|
|
Threaded Mode